CUT_PLUNGE refused: run CUTTER_MODE first |
File built with --no-wrap, or mode reset by a restart |
Run CUTTER_MODE or rebuild without --no-wrap |
CUT_PLUNGE refused: home all axes |
Klipper restarted since the last G28 |
G28 |
Unknown command: "CUTTER_MODE" |
Macros not included |
Klipper macros step 2 |
mode_switch.py exit 1, Connection refused |
Wrong host, or port 7125 blocked |
curl http://<host>:7125/server/info; check TRIAINA_HOST |
mode_switch.py upload exit 1, no such file |
Wrong path |
Check the path; it is relative to where you run it |
mode_switch.py exit 1, HTTP 401 |
Moonraker or OctoPrint auth on |
Pass --api-key |
/dev/triaina missing (console cable) |
Rule not installed, or other USB bridge |
Replug; lsusb; setup_pi.sh --udev --vid XXXX --pid XXXX |
| Pi shows a lightning bolt / undervoltage |
Weak supply, or back-feed over the console cable |
Official PSU; check the Kapton tape |
| Printer LEDs on with printer switched off |
5 V back-feed |
Tape slipped; redo it or use a blocker |
| Cut shifted by a constant amount |
Offset wrong |
Calibrating the knife step 1 |
| Rounded or open corners |
Too fast, or no blade-offset compensation |
Lower --max-feed; use Inkcut's blade offset filter |